Lining up the wall with the base
|
Applying pressure to make sure the glue will have a good bond.
|
Test fitting another piece to judge clearance on the camera and to know where it should go.
|
Note the glue smoothed out along the edge, I applied another layer just to give it a little more supprt and to fill any tiny holes.
|
My helper for this project and also happens to be my grlfriend. Glad she puts up with my strange projects. |
Cutting out a spot for the camera on the base, it took a while to carve out exactly. Didnt want to remove to much material. |
I kept test fitting the camera to see if the case would fit. Took a few tries to get it just right. |
Finally got the camera seated where it needed to be without the camera seeing the side of the pink foam. |
Page 4 of 12